Correction to: Superior Stability and Efficiency Over 20% Perovskite Solar Cells Achieved by a Novel Molecularly Engineered Rutin-AgNPs/Thiophene Copolymer (Advanced Science, (2018), 5, 11, (1800568), 10.1002/advs.201800568)

Adv. Sci. 2018, 5, 1800568 Because of barriers in communication between Ahmed Mourtada Elseman (the first author) and the Chinese students (responsible for the device fabrication), the formulation of the component of perovskite in the manuscript is FA_0.25MA_0.75PbI₃, rather than CH₃NH₃PbI₃. The detailed correction locations are as follows: 1) On page 3: “which are more positive than that of CH₃NH₃PbI₃” should read “which are more positive than that of FA_0.25MA_0.75PbI₃.” 2) On page 7: “The CH₃NH₃PbI₃ films were fabricated using…” should read “The FA_0.25MA_0.75PbI₃ films were fabricated using…”; and “The perovskite precursor solution contained 159 mg of CH₃NH₃I and 461 mg of PbI₂ in anhydrous DMF/DMSO…” should read “The perovskite precursor solution contained 43 mg of CH₅N₂I, 119 mg of CH₃NH₃I and 461 mg of PbI₂ in anhydrous DMF/DMSO…” Moreover, the fitted current of IPCE in Figure was calculated improperly because the wrong integral area was used. The corrected Figure is displayed below. 4d (Figure presented.) Internal quantum efficiency (IQE) spectra and integrated current curves of the corresponding devices. The authors state that the corrections do not influence the motivation, opinions, or scientific outcome of this paper, and apologize for any inconvenience this may have caused.